The gearbox is now finished, and glued into the hull together with the engine. Adding all the small details was actually a lot of fun. I then pushed the bent side parts a bit apart using a piece ofthick styrene sheet, added the fasteners of the stowage boxes on both sides, and finally glued the bench on its place at the back. I also soldered together a frame holding the hatches that regulate the cooling air intake (located below the bench), and glued it into the hull. On the last pictures, the driver’s seat can be seen with its mount, also soldered together from scratch. The pin will be fitted into the lower part of the mount to fix the seat permanently later on.